Vision Refurbishments LtdWe achieve your vision Which? Trusted Trader
020 3987 4923

What does an irregular-shaped house mean for the costs of an open plan conversion?

Tap + for quick options

Skip to main content
Print

What does an irregular-shaped house mean for the costs of an open plan conversion?

We are looking at buying a semi-detached house built around the 1930s. The house has a slightly irregular shape – the two side walls are not parallel, so the house is 1m or so wider at the back than the front. We want to remove two perpendicular internal load-bearing walls (~3m each) that currently separate the kitchen from the reception and the hallway (which may require a pillar). This will create an open plan kitchen-diner, and we will use part of the old kitchen space to create a downstairs bathroom. My question is what might be a ballpark range of costs for the structural work (removing walls and doorways etc.)? And what extra costs does the irregularity of the building add to the cost? I’m concerned that costs of RSJs and structural engineering fees could spiral if the shape adds complexity. Any advice gratefully received!

========================

Answer:-

For a 1930s semi with two perpendicular load-bearing walls to be removed (around 3m each), a typical ballpark for the structural work alone — including structural engineer design, supply and fitting of RSJs (steel beams), and making good (plastering etc.) — would usually be in the range of £4,000 to £8,000.

Here’s how that breaks down roughly:

  • Structural engineer: £500–£1,200 (depending on complexity and number of beams).

  • RSJs and fitting: £2,000–£5,000 (materials, labour, and support work).

  • Making good (plaster, skirting, floor levelling): £1,000–£2,000.

Now, because your house is slightly irregular in shape, with walls that aren’t parallel, it can increase costs modestly — not dramatically, but enough to notice.
Here’s why:

  • Custom beam sizing or angles: Non-parallel walls mean the steelwork might need to be fabricated to fit specific angles, not straight spans. That adds both design and manufacturing cost.

  • Extra engineering time: The structural engineer will need to model the loads more carefully, especially if the house tapers, which can increase their fee by a few hundred pounds.

  • More on-site labour time: Fitting angled beams and ensuring level finishes in a non-square space takes longer.

Overall, you might be looking at an extra 10–20% added to the usual cost for a straightforward rectangular plan — so perhaps £5,000 to £9,500 total for the structural side of your open-plan conversion.

If you’re adding the downstairs bathroom as part of the same job, plumbing, drainage, and finishing will add a separate £3,000–£6,000, depending on fittings and layout.

==========================
Contact Us :
📞 (0)20 3987 4923
📱 Mob: 07404960364
📧 info@vrltd.uk
📍 566 Chiswick High Street, W4 5YA, London

Table of Contents