Vision Refurbishments LtdWe achieve your vision Which? Trusted Trader
020 3987 4923

Concerns with tiling

Tap + for quick options

Skip to main content
Print

Concerns with tiling

Currently having a bathroom installed but have some concerns about the quality of the tiling work done so far. I noticed the tiler started with a dot and dab method on the walls, I was aware this is not a recommended method so asked him not to continue with this and sort out what he’d done so far and use the British tiling standards method. He said this was fine. I’ve had a chance to suss out what’s been done so far and have some concerns. There are uneven and large gaps around the floor tiles, up to 2cm in places. The half height wall tiles over the bath are standing around 1cm proud of the plaster with what looks like very thick adhesive, even with the chrome trim on the top there’s a big gap between this and the wall. I’m worried about the quality of the job but wanted to check is this something that will resolve with application of grout etc to not be noticeable or do I have good reason to raise these concerns?

===============

Answer;-

Based on the details you’ve provided, you have valid reasons to be concerned about the quality of the tiling work. Let’s break down the issues:

1. Dot and dab method: You were correct to ask the tiler to stop using this method for wall tiling. The British Standards (BS 5385) recommends full coverage of adhesive for wall tiles, especially in wet areas like bathrooms.

2. Uneven and large gaps around floor tiles: Gaps up to 2cm are excessive. While grout can fill small gaps, 2cm is far too large and indicates poor planning or execution. Standard grout lines are typically 2-3mm wide.

3. Wall tiles standing proud of the plaster: A 1cm difference between the tile surface and the plaster is significant. This suggests either the adhesive was applied too thickly or the wall wasn’t properly prepared. A small amount of buildup is normal, but 1cm is excessive.

4. Large gap between chrome trim and wall: This further indicates issues with tile thickness or wall preparation.

These issues are unlikely to be fully resolved by grouting alone. While grout can hide minor imperfections, it cannot compensate for significant unevenness or large gaps. Here’s what you should consider:

1. Document the issues: Take clear, well-lit photos of the problems you’ve noticed.

2. Communicate with the tiler: Raise your concerns professionally, showing the photos and asking for their plan to address these issues.

3. Seek a second opinion: If possible, have another professional tiler or building inspector assess the work.

4. Know your rights: If this is part of a larger renovation project, review your contract for quality assurance clauses.

5. Consider future implications: Poor tiling can lead to water ingress, tile cracking, or grout failure over time.

It’s better to address these concerns now rather than after the job is completed. A high-quality tiling job should have even, consistent grout lines, be level with minimal lippage (height differences between adjacent tiles), and sit flush with trims and adjacent surfaces.

==========================
Contact Us :
📞 (0)20 3987 4923
📱 Mob: 07404960364
📧 info@vrltd.uk
📍 566 Chiswick High Street, W4 5YA, London

Table of Contents