Vision Refurbishments LtdWe achieve your vision Which? Trusted Trader
020 3987 4923

Installation of a wetroom

Tap + for quick options

Skip to main content
Print

Installation of a wetroom

Hi, I am hoping to build a small rear extension to house a wetroom for my disabled father. The floor will be concrete. My question is I know I will need to install drainage but what other material will be needed to be installed in the concrete slab as it’s being installed for the wetroom as the extension will be newly constructed? Thanks

=========================

Answer:-

When you’re building a new extension specifically for a wetroom, it’s much easier (and cheaper) to get everything prepared while the concrete slab is being laid, rather than trying to adapt it later.

Along with the drainage, here are the key things you should plan into the slab and structure from the start:

First, falls and levels. Even with a concrete slab, the wetroom area needs a proper fall towards the drain. This is usually created either by forming the fall in the slab itself or by allowing enough depth to add a screed later that can be shaped to the drain.

Second, drain type and positioning. Decide early whether you’re using a centre drain or a linear drain, as this affects where pipework runs and how the floor is formed. The waste pipe will need the correct gradient and access for maintenance.

Third, waterproofing (tank­ing). This is crucial. The slab itself isn’t waterproof, so you’ll need a full tanking system over the floor and up the walls (usually at least 300mm, often higher in shower areas). This normally includes:

  • A waterproof membrane or liquid tanking system

  • Sealing tapes for wall–floor joints

  • Pre-formed corner pieces

Fourth, insulation. Building regulations usually require insulation under the slab and sometimes above it. This also helps prevent cold floors, which is important for comfort, especially for someone with limited mobility.

Fifth, underfloor heating (optional but worth considering). If you’re thinking about underfloor heating, the pipework or electric mats should be planned now, with enough build-up allowed above the slab.

Sixth, wall preparation. Make sure the walls are suitable for tanking and for fixing grab rails, shower seats, and screens. It’s a good idea to install additional timber noggins or reinforcements in the walls at this stage.

Finally, ventilation. Wetrooms produce a lot of moisture, so a good extractor fan (often with humidistat) and ducting should be planned during construction.

In short, if you plan drainage, falls, waterproofing, insulation, and fixings at the slab stage, you’ll avoid most future problems. I’d strongly recommend discussing the layout with your builder and plumber before the concrete is poured, and if possible, following a recognised wetroom system manufacturer’s guidance.

==========================
Contact Us :
📞 (0)20 3987 4923
📱 Mob: 07404960364
📧 info@vrltd.uk
📍 566 Chiswick High Street, W4 5YA, London

Table of Contents